Vibe FWD L4-2.4L (2009)
Valve Body: Service and Repair
MVB 4 Speed - Automatic Transmission
Control Valve Body Replacement
Removal Procedure
1. Disconnect the cable from the negative battery terminal. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
2. Remove the left hand side engine splash shield.
3. Remove the drain plug and gasket, and drain ATF.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install a new gasket and the drain plug and tighten to 49 Nm (36 ft lb).
Note: Some fluid will remain in the oil pan. Remove all the oil pan bolts, and carefully remove the oil pan sub-assembly.
5. Remove the bolts and remove the oil pan and oil pan gasket.
6. Remove the magnets (1) from the oil pan.