911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-943002.png)
procedure is not required at present.
1. Attach electric plug connection to multi-function control unit until the plug clicks into place.
2. Clip multi-function control unit into steering wheel. Check that it is secure.
INFORMATION:
-
When removing the locking plate, take note of how many washers are used on each fastening screw.
-
During installation make sure that the washers are fitted in the same way as they were before removal.
3. Position locking plate on steering wheel and screw down using the four fastening screws -1- and the washers. - Tightening torque: 4.5 ftlb.
Subsequent work
Subsequent work for multi-function control unit
Install driver's airbag unit.
