911 Carrera (997) F6-3.6L (2006)
WARNING: Danger of scalding from hot pressurised coolant.
^
Only work on the coolant system when the engine is "cool".
^
Wear protective gloves and goggles.
1. Open cap on expansion tank -1- and remove. Set steel chamber for bleeder valve to vertical -2-.
WARNING: Danger of scalding from hot pressurised coolant.
^
Only work on the coolant system when the engine is "cool".
^
Wear protective gloves and goggles.
WARNING: Coolant is corrosive and hazardous to health.
^
Skin and eye irritation
^
Wear protective gloves and goggles.
^
If you come into contact with coolant, wash off immediately with plenty of warm water.
2. Undo internal hexagon socket drain screw from coolant inlet pipe. Open spring clamp on hose at inlet side of the water pump, remove the hose and
unscrew the drain plug. Collect coolant in a clean container. Next reassemble the hose and screw the drain plug back with a new sealing ring.
Tightening Torque: 7.5 Ft. lb. + Ft. lb.
WARNING: Danger of scalding from hot pressurised coolant.
^
Only work on the coolant system when the engine is "cool".
^
Wear protective gloves and goggles.