911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-251002.png)
5. Unscrew two M6 x 20 inner Torx screws -2- at the valve holder and remove the holder along with the screws -A-.
Note:
^
Handle the hydraulic valve with care, do not turn It at the valve t1p or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
6. Carefully pull the hydraulic valve out of the cylinder head using special tool relay puller 9235. Before using the puller, mask the valve body in
fabric tape in order to prevent slippage or damage.
7. Remove retainer plate with integrated seal -1 - from the valve.
Note:
^
Handle the hydraulic valve with care, do not turn It at the valve t1p or at the safety contact.
^
A seal against leaks cannot be ensured if there is damage in the area of the retainer plate, therefore handle the pliers indicated with care.
8. Check the valve body for damage in the sealing area of the retainer plates. If necessary, the valve must be replaced.
