911 Carrera (997) F6-3.6L (2006)
Oil-pressure sender tool
^
1 - Crowfoot wrench a/f 19 NR.11-1 (snap-on).
^
2 - Extension 3/8-inch, 16° moveable NR.15.
1. Remove both cable plugs in engine compartment (cylinder head cover, side 4-6).
2. Remove cover plate for ignition coils. Unscrew two M6 Torx screws and remove plate.
Cover plate for ignition coils
Information
The sender is removed from and fitted onto the underside of the engine, therefore the direction of rotation must be observed.
^
Undo: in a clockwise direction.
^
Tighten: in an anticlockwise direction.
3. Remove oil-pressure sender with Extension 3/8-inch, 16° moveable NR.15 and a crowfoot wrench a/f 19 NR.11-1 -1-. Use a long, 3/8-inch
extension -2- also.
Tool usage - oil-pressure sender
Installing oil-pressure sender