911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-1193001.png)
Door Lamp: Service and Repair
961619 Removing And Installing Door Warning Light
Removing bulb for door warning light
ATTENTION:
Danger of damage to property if bulbs are used or handled incorrectly.
-
Risk of damage to bulbs and bulb housing.
-
Switch off ignition and remove ignition key.
-
To prevent short circuits, the load in question must be switched off while changing bulbs.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing
bulbs.
-
In certain states, it is compulsory to carry spare light bulbs.
Diagram of door warning light
Removing door warning light
1. Push door warning light carefully out of the door trim via the cutaway -arrow- using a screwdriver.
2. Pull off door warning light connector and remove light.
Removing bulb for door warning light
