911 Carrera (997) F6-3.6L (2006)
1. Disengage securing clip.
Pulling off electrical connector
2. Pull electrical connector off bulb and remove bulb.
Removing high beam halogen bulb
Installation position
Unscrewing bayonet lock
1. Unscrew high beam bulb, bayonet lock counter-clockwise.
Unplugging electrical connector
2. Unclip electrical connector -a- and unplug.
Installing halogen bulb
ATTENTION:
Danger of injury. Danger of material damage if bulbs are used or handled incorrectly.
-
When installed, the headlight has a high voltage.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
To prevent short circuits, the load in question must be switched off when changing bulbs.
-
New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands. To change the bulbs, use a cloth or soft paper.
-
Observe the safety instructions when replacing a bulb in a Bi-Xenon headlight.