911 Carrera (997) F6-3.6L (2006)
Underhood Light Bulb: Service and Repair
Removing and Installing Bulb For Engine Compartment Light
Removing And Installing Bulb For Engine Compartment Light
Removing bulb for engine compartment light
Removing engine compartment light
ATTENTION:
Danger of damage to property if bulbs are used or handled incorrectly!
-
Risk of damage to bulbs and bulb housing.
-
Switch off ignition and remove ignition key.
-
To prevent short circuits, the load in question must be switched off while changing bulbs.
-
Only bulbs specified in the bulb table may be used.
-
Bulbs with a higher wattage may damage the bulb housing.
-
New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing
bulbs.
-
In certain states, it is compulsory to carry spare light bulbs.
1. Disengage wiring harness on blower motor housing.
2. Press engine compartment light carefully out of the blower motor housing at the cutout -arrow- using a screwdriver.