911 Carrera (997) F6-3.6L (2006)
6. Position mounting head approximately 15 cm to the right of valve and pull the second tyre bead (upper tyre bead) onto rim.
WARNING: If the tyre seating pressure is too high (max. 4 bar permissible), personal injuries due to possible tyre or wheel destruction
are possible.
^
Maximum tyre seating pressure 4 bar! This value must not be exceeded!
^
For tyre seating pressure over 3.3 bar (possible in the event that several unfavorable factors should occur simultaneously / max. 4.0 bar
permissible) use a tyre filling cage.
7. Remove entire wheel from tyre fitting unit. Without valve insert, fill tyre with air until tyre beads slide over hump (to a maximum of 4.0 bar).
8. Screw in new valve insert and fill tyre to specified tyre pressure. Screw on valve cap.