911 Carrera (997) F6-3.6L (2006)
9. Pull connector out of the connector housing -Arrow C-.
10. Release connector guide on both sides -Arrow a- and slide down from the contact strip.
NOTE: Allocation of lines - see wiring diagram.
11. Release contacts of the damaged lines using the press-out tool 1575-1P of the press-out and unlocking tools for flat and round plug connections of
every size NR.155 (-Arrow a-) and pull out of the contact strip.
12. Cut off the contacts of the damaged lines, insulate them and secure them to the main wire harness with tie-wraps.
13. Insert wire puller -1- with the flexible end on the right side -Arrow into the rubber sleeve -2-. Coat the wire puller -1- with soapy water and slide it
through the rubber sleeve -2- (-Arrow A-).