911 Carrera (997) F6-3.6L (2006)
27. Push on connectors on control unit for rear convenience systems -46 to 48- until they engage securely.
28. Push on connectors on ParkAssist control unit -44 and 45- until they engage securely.
29. Push on connectors for centre airbag sensor at the left and right -42 and 43- until they engage securely.
30. Push on connector on Tiptronic control unit -41- until it engages securely and lock it.
30.1. Clip in wire harness for Tiptronic control unit.
31. Fit rubber sleeves -39 and 40- and push on connector for front seat-belt pretensioners at the left and right -37 and 38-.
32. Connect plug connection between main wire harness and rear wire harness at the left and right -33 and 34- and lock it.
Completing the vehicle
1. Install left and right support.
1.1. Position the support and engage in lower side member.
1.2. Press in the locating peg -1- of the support and check it is seated correctly.
1.3. Tighten the fastening nut -3- and fastening screws -2-. - Tightening torque: 7.2 Nm (5.5 ftlb.)
2. Lay the floor covering over the support and engage.
INFORMATION: Ensure that belt strap can run properly.