911 Carrera (997) F6-3.6L (2006)
Engine Control Module: Service and Repair
247019 Removing and Installing DME Control Module
Tools
Preliminary work
Subsequent work on DME control unit
Remove the cover above the heating/air-conditioning system and fluid tank.
If a new DME control unit is installed, then read out the vehicle data from the DME control unit and transfer them to the new one.
1. Connect the PIWIS Tester 9718 to the vehicle and start the System Tester. Switch on ignition. Press ">>" to continue.
2. Select vehicle type. Press ">>" to continue.
3. Carry out automatic search of control units.
4. Select DME with the cursor keys and press the ">>" key.
5. Select Program control unit with the cursor keys and press the ">>" key.
6. Select Read out vehicle data (Vehicle data) with the cursor keys and press the ">>" key.
7. The message Reading vehicle data will appear on the tester screen.
8. After replacement of the DME control unit, the vehicle data is uploaded from the Program control unit menu option.
General warning notes
General warning notes for control units
WARNING: Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery charger
with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
Removing DME control module