porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 3532 > < Procedures|Page 3530
Page 40
background image

68

Connector for stop light switch

69

Connector for pedal sensor

70

Plug connection between main wire harness and wire harness for centre console

71

Plug connection for telephone handset

72

Connector for airbag triggering unit

73

Connector for parking-brake lever contact switch

74-75

Tiptronic position switch

76

Ground point under unit carrier

77

Connector for tilt sensor control unit

78

Power distributor

79-80

Plug connection between main wire harness and wire harness for heater/air-conditioning unit

81-82

Connector for garage door opener control unit

83

Connector for sunroof switch

84

Connector for interior light

85

Connector for sunroof motor

86

Plug connection for rain sensor

87-88

Plug connection for make-up mirror, left and right

89-93

Connector for antenna unit, left and right.

1. Release plug connection between main wire harness and rear-end wire harness, left and right -33 and 34- -Arrow A- and disconnect.

2. Pull off connector for seat-belt tensioner, front left and right -37 and 38- and remove rubber sleeves -39 and 40-.
3. Release and pull off connector on Tiptronic control module -41-.

3.1. Unclip wire harness for Tiptronic control module.

4. Release and pull off connector for airbag sensor, centre left and right -42 and 43-.
5. Release and pull off connector for ParkAssist control unit -44 and 45-.
6. Release and pull off connector for rear end convenience systems control unit -46 to 48-.
7. Loosen ground point under the driver's seat -49-.

7.1. Screw off fastening nut and remove ground straps.

Procedures|Page 3532 > < Procedures|Page 3530