911 Carrera (997) F6-3.6L (2006)
5. Push the ABS wire harness inward -arrow-.
NOTE: Only for vehicles with HBA.
6. Cut through the rubber sleeve -a- and insert the HBA line-arrow A-. Stick the rubber sleeve together at the cut edge -a- using a commercially
available PUR adhesive and seal. Press the rubber seal into the opening -arrow B-.
NOTE:
-
Select a place for the joint where there is enough space to join all the lines present.
-
Do not cut the lines too short in case they have to be laid in a different position if there is insufficient space in the area of the joint.
-
The greatest care must be used in the individual work steps for stripping insulation from, crimping, and shrinking/insulating the electric lines.
-
The procedure for stripping insulation from, crimping, and shrinking/insulating the electric lines must be complied with and observed. The
procedures are described in detail in the repair kit for harnesses NR.155-1.
-
Crimping samples are to be prepared before beginning work.