911 Carrera (997) F6-3.6L (2006)
Seals and Gaskets: Procedures
Removing and Installing Torque Converter Sealing Ring
Removing and installing torque converter sealing ring
Tools
Information
Note: When pulling out, the torque converter must be kept horizontal, otherwise ATF can emerge.
Note: Before installing the torque converter, check the hub for scoring. If damaged, the converter must be replaced.
Preliminary work
1. Remove transmission.
2. Put transmission in horizontal position.
Removing the torque converter
1. Pull out fixing pin 95951 (long) from transmission housing.
Note: When pulling out, the torque converter must be kept horizontal, otherwise ATF can emerge.
2. Screw two screws (M8) into torque converter and remove torque converter using the screws from transmission input shaft.
Removing the torque converter sealing ring