911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Spoiler: Adjustments
Adjusting the Rear Spoiler
The rear spoiler running out and running in travel can be limited and, therefore, adjusted by determining the switching points of two micro-switches.
Note: For items shown in this image, but not identified in the adjustment procedures, please refer to Service and Repair. See: Service and Repair
Adjusting the Micro-switch for Spoiler Running In
Operate the service switch to run in the spoiler until the tab (A) of the arced tooth element (47) is disconnected in opening (B) of the guide lever
(C).
Unscrew hexagon nut (25).
Adjust the switching point of the micro-switch (27) on stud (28).
Tighten hexagon nut (25) again.
Recheck adjustment by operating the service switch.
Adjusting the Microswitch for Spoiler Running Out
Operate the service switch to run out the spoiler until lever (39) touches pad (51).
Adjust the switching point of the micro-switch (23) on stud (24).
Recheck adjustment by operating the service switch.