911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Parking Brake System: Adjustments
1.
Raise and support vehicle.
2.
Remove rear wheels.
3.
Release brake cable tension at adjusting nuts behind disc splash shield.
4.
Insert screwdriver into adjustment opening in rear brake disc assembly.
5.
Rotate parking brake adjustment sprocket so that disc can no longer be rotated by hand.
6.
Repeat step 5 on opposite side.
7.
Adjust cable tension until slack is removed by rotating adjustment nuts behind brake disc splash shield.
8.
Remove tunnel cover and parking brake lever boot and check position of cable equalizer.
9.
Position the equalizer in the two inspection holes when lever is pulled up.
10.
To adjust the position of equalizer, rotate the adjustment nuts behind splash shield.
11.
After equalizer has been properly positioned, lock adjustment nuts.
12.
Back off adjustment sprockets inside each brake drum 4-5 teeth, so that disc rotates freely. The parking brake should be set when the lever is
pulled up 2 clicks.
