911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
drawing, part no.14.
2. Punch centering pin and drill with a 2.5 mm dia. drill, tap an M 3 thread and use an M 3 bolt and spacing sleeve to pull out pin.
Installation
1. Install spray tube in correct position, making sure the locating bore for the lock pin Is oriented correctly, e.g. use a piercing awl to check. Coat
centering pin lightly with Loctite 270 and press in.
Note: Individual bores must point up towards the inlet valve covers. Twin bores (not visible on figure) point towards the cam sliding surface.
2. Coat new lateral plugs with Optimoly HT and press in plugs.
Note: Align bevelled edge of the plugs so that it points towards the bore. If the plugs cannot be press-fitted in the housing, upset them before
fitting them.
3. Press in the plugs until they are approx. 0.3 mm below the sealing surface.
