911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
2. Undo oil drain plug at oil filter console and drain remaining used oil into a suitable container.
3. Undo the oil filter with a standard clamping band, e.g. Hazet 2171 - 2. Catch any remaining oil.
4. Clean the drain plug. Always replace the sealing rings. Tightening torque for the drain plug on the crankcase 50 Nm (37 ft. lbs.). Drain plug on the
thermostat housing 50 Nm (37 ft. lbs.) and oil filter console plug 31 Nm (23 ft. lbs.).
5. Apply a light film of oil to the seal on the oil filter, install by hand, turning until the seal makes contact. Finally, tighten by a further approx. 1/2
turn.
6. Fill with approx. 6 liters of engine oil. Run the engine at idle and top up with approx. 3 liter. The oil-change volume amounts to approx. 9 liter.
Only use approved engine oils.
Check the oil level at operating temperature and at idle speed. Check the engine, oil reservoir, lines and front oil cooler for leaks (visual inspection).
