911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
12. Pull off condensation and rain water drain hoses (cut off straps) and press out molded rubber grommets upward.
13. Discharge the air conditioner (draw off refrigerant with a recycling machine),
14. Unscrew refrigerant pipes on expansion valve.
15. Disconnect Frigen switch plug.
16. Unscrew holder for refrigerant pipes.
17. Pull off air guides to the side nozzles.
18. Remove radio.
19. Remove heater/air conditioner controls.
20. Pull off left and right warm air guide necks.
21. Disconnect wire harness no. 180 (is fastened on the passenger compartment wire harness).
22. Disconnect plug T 5 (underneath dashboard).
23. Unscrew mounting screws and nuts.
Installation
1. Install in the reverse order of removal.
NOTE: When installing, insert the right air guide prior to complete installation of the heater/air conditioner (better accessibility). The left air
guide can be inserted with an installed heater/air conditioner after removal of the large instrument cluster dial.
