911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Power Steering Pump: Testing and Inspection
Checking Hydraulic Operation of Steering System
- (pressure measurement) -
General
The tester (pressure gauge) is connected between the power pump and the press. line. If the old press. gauge is used, pay attention to the correct
installation position. For better understanding of the below described, the connection and lever positions have been identified.
Old version
V.A.G. 1402
I - Shutoff valve open
II - Shutoff valve closed
III - Damping orifice
IV - from power pump
V - to pressure line
Fitting the Pressure Gauge
1. Take off air cleaner cover complete with filter element.
2. Undo pressure line at power pump. Catch hydraulic fluid in a container (do not reuse).