911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
2). After cutting metal, apply rust prevention paint.
4.
On the front fender, from approximately 150mm above the rocker panel to the front bumper, the inner fender edge has to be bent up. Do not cut or
grind this edge off. Also the metal edge of the fender has to be cut off. See Figure 2.
5.
No tire chain clearance.
Please replace pages 7 & 8 of Technical Bulletin Group 4, # 9312, dated 11-2-93 with this page.
