911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Clutch Release Bearing: Technical Service Bulletins
Clutch Release Bearing & Guide Sleeve - Revised
Group
3
Number
9302
Model 911 C2/C4
911 Turbo
Part Identifier
3045
March 30, 1993
Subject:
911 Clutch Release Bearing
ATTENTION:
Service Manager/Service Technician
Models Affected:
911 Carrera, 1987-on
911 Carrera 2/4, 1989-on
911 Turbo, 1991-on
General Information:
A new version clutch release bearing and guide sleeve is now available. The new bearing has a polyamide insert which contacts the guide sleeve. The
inner diameter of the release bearing and the outer diameter of the guide sleeve are 2 mm smaller than the former version. The new version release
bearing and guide sleeve has been used in production since November 5, 1992, as of engine number 62P 02375.
Parts Description:
The new version release bearing can be identified by a polyamide insert which is slit (see Figure 1) and an inner diameter of 32 mm. The new version
guide sleeve can be identified by measuring the outside diameter of the guide sleeve. It measures 31.8 mm (see Figure 2).
Release Bearing
32.0 mm (formerly 34.0 mm)