911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Required Materials:
Paint, matched to car color code
Adhesive tape
Cleaning cloth
Labor:
References:
911 Carrera (996) Technical Manual, Group 6:- Repair: 63 55 19 - Removing and installing rear bumper covering
Paint Manual, 4/6/8 cylinder, plastic painting
Fitting
1.
Preparatory work.
Damage or warping can occur on components in the event of improper painting and drying processes! Observe the specifications and instructions for the
painting of plastics as stated in the Paint Manual, part number WKD 482 620.
1.1
Mount both GT rear side skirts on at least two threaded pins for painting and drying. Paint them as described in the Paint Manual (material: PUR).
1.2
Remove rear bumper covering, see 911 Carrera (996) Technical Manual, Group 6, Part ID 6355 and place it on a cushioned surface.
2.
Fitting both GT rear side skirts.
2.1
Remove both drilling templates from the boxes.
2.2
Place the corresponding mounting side of each of the drilling templates on the outside of the rear bumper covering and align as described below:
-
parallel to lower edge of groove
-
align the dashed line on the projecting end of the drilling template with the seam of wheel housing and place it around the seam of the wheel
housing (Figure 2).
Affix the drilling templates in the end position on the rear bumper covering with adhesive tape.