911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Front Cross-Member: Service and Repair
Front-axle cross member - permissible combinations
New front-axle cross member - as of model '02
-
As of model '02, the front-axle cross member is attached to the body at the rear fastening with two screws -arrows-. Up to this (up to the end of
model '01), only one screw was used in the fastening.
-
The tightening torque has not been changed.
-
The previous front-axle cross member -F1-, with one fastening screw securing it to the body (per side) is still available as a spare part.
-
Only certain combinations of front-axle cross member attachment -F1 or F2- to the body is permitted!
F2 - 2 fastening points (as of model '02)
F1 - 1 fastening point
Allocating the front-axle cross member to the body
Caution! Material damage will result in the area of the axle mount/axle fastening due to reduced strength, if correct allocation is not observed!
-
Only install permissible combinations of front-axle cross member to the body (standard construction)!
-
Do not install front-axle cross members with one fastening screw (F1) in vehicles with two body mounting points (K2)!
Impermissible combination
Front-axle cross member with one fastening bore -F1- and body with two fastening points -K2-.
-
Attention: Impermissible combination!
Permissible combinations
Front-axle cross member with one fastening bore -F1- and body with one fastening point -K1-.
-
Standard construction up to end model '01.