911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
9
-
Fastening tension cable of the convertible-top covering
-
Position the tension cable eyelet -3- on the main bow and fasten with the T25 -4- Torx screw.
Tightening torque: 7 Nm (5.0 ftlb.)
10
-
Fastening convertible-top covering on the tension bow
NOTE: Cutouts have been integrated to the right and left of the additional seal.
1. Integrate the additional seal parallel to the tension strap -C- into the cutouts on the right and left using a knife.
2. Press tightening strip centre (notch marking) -inset A- into the lower groove of the tension bow -inset B- (centre of the tension bow is
identified by a hole) -inset A-.
3. The reference overlap seams of the convertible-top covering must be positioned and centered in the additional seal -arrow C- cutouts on
the left and right.
4. Secure the convertible-top covering by tapping in the seal -inset D-.
11
-
Fitting tension bow seal
1. Press tension bow seal into the lower groove of the tension bow and fasten at both ends with the T25 Torx screws -2-.
Tightening torque: 5 Nm (3.5 ftlb.).