911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
No. 6 - 9
Adjusting the gap dimensions of the rear side section trim
Measurement Locations
Adjusting gap dimensions
(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The adjustment, Figure C, is made by means of the Torx
screws in the flap.
Dimension A = 4.0 + 2.0 mm gap width between the rear side section trim and side section trim.
Dimension B = 3.0 + 2.0 mm gap width between the roll-over protection system cover and rear side section trim.