911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Convertible Top Deck Lid Motor: Service and Repair
Motor For Rear Side Section Flap
Removal
NOTE: Motor and electrical plug connection are one replacement part. If the motor is faulty, the wires of the micro switches must be removed.
Removing and installing micro switch for rear side section flap. See: Convertible Top Deck Lid Position Switch / Sensor/Service and Repair
Removing and installing rear side section flap. See: Convertible Top Deck Lid/Service and Repair
1. Remove rear side section flap.
2. Undo and remove motor with screwdriver (Torx T 10).
Fig. 1
3. Unclip wires for micro switches.
4. Pull motor with rear side section flap downwards and remove spindle from the spindle guide.
5. Remove wires for micro switches from the plug connection.
Installation
1. Insert motor into the spindle guide with the spindle and fasten motor.
2. Install wires for micro switches into the plug connect and clip in wires.
3. Install rear side section flap and perform a function test.