911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
the seal -7.2- using rubber sliding compound for example Capella or tire mounting paste. Recheck that it is seated correctly and correct if
necessary!
3. Mount seal -7.3- and coat with Capella or tire mounting paste.
4. Mount intermediate piece -11- (2 M8 nuts and hexagon socket head bolt). Tightening torque of the 2 M8 nuts = 23 Nm (17 ft. lbs.).
5. Install battery.
6. Install new pushrod (if not already present) -12.1- in place of -12-. When doing so, observe installation dimension X (138 mm).
Basic setting of the push rod -dimension X- is 138 mm (set in new brake boosters)! If necessary, correct during the relevant work!
7. Install brake booster and brake master cylinder with mounted bellows -B- and tightened clamps -6-.
Note! Before using the brake booster, push the screw clamp -6.1- onto the bellows -B- or onto the brake pushrod!