911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Variant A1: Spare version for A
With this variant -A1-, the new/current continuous bellows -B- is used instead of the 2 rubber bellows. A seal -7.2- is used together with an
appropriate connection sleeve -7.1- for connection to the firewall! In addition, the 2 brake pushrods (on the brake booster and of brake pedal) must
also be replaced!
The conversion is described in "Converting brake booster (bellows)".
Note!
-
As a replacement part, the brake booster is delivered with the new/current continuous bellows -B-!
-
In general, the following applies: The bellows -B- must be installed!
Installation
Note! Basic setting of the push rod -dimension X- is 138 mm (set in new brake boosters)! If necessary, correct during the relevant work!
1. Insert the brake booster with bellows -B-.