911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-1354003.png)
2. Connect electrical plug connection.
3. Position the support and engage in lower side member.
4. Push in the locating peg -1- of the support and check that it is sitting correctly.
5. Tighten the fastening nuts -3- and the fastening screws -2-.
Tightening torque -2- 7.2 Nm (5.5 ftlbs.).
6. Lay the floor covering over the support and engage.
-
Using the Porsche System Tester, read out any faults present in the POSIP menu and erase. Refer to Diagnose/airbag troubleshooting
-
Insert sill. Refer to Removing and installing sill
-
Mount the side lining at rear. Refer to Removing and installing side lining
-
Installing front seat. Refer to Removing and installing front seat
Tools
