911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Special Tools
9. Unlock the old contacts with the unlocking tool, and remove.
Installation
1. Install the new contacts of the potentiometer in the same position as follows:
-
Green wire (pin 1) to pin 9
-
Yellow wire (pin 2) to pin 4
-
Red wire (pin 3) to pin 8
Close the secondary lock of the plug connection with a small screwdriver again.
2. Wind insulation tape around the wires and install potentiometer. Engage electrical plug connection.
3. Install hydraulic cylinder and rear left side-panel lining.
See Removing Convertible Top procedure No. 6 to No. 8. See: Body and Frame/Roof and Associated Components/Convertible Top/Service and
Repair