911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
2. Remove side-panel lining in front of the center console on the left -A- and right.
3. Remove fastening nuts of the rate-of-turn sensor on the right -arrow- and left.
4. Pull out the rate-of-turn sensor and unlock and pull off the connector with the ignition switched off.
NOTE: Pull at the connector housing only. Never pull the electrical connections.
Installation
1. Install in reverse order.
2. After installing the rate-of-turn sensor, read out the PSM fault memory with the Porsche System Tester 2 and erase. Carry out a static test. Then
start the engine. The PSM-related lights in the instrument cluster must go out when the engine is running. Read out the PSM fault memory again.
There must not be any stored faults.