porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Lock Barrel Replacement|Page 4800 > < Steering Column Lock|Diagrams|Page 4797
Page 1
background image

Steering Column Lock: Service and Repair
Lock Barrel Replacement

Removal 

1. Disconnect battery ground cable.
2. Pull cover (collar) off the steering lock.
3. Insert ignition key and turn to position 1 (ignition on). Insert a steel wire (C) with a diameter of approximately 1.3 mm (max. 1.5 mm [diameter])

into the bore next to the ignition key (arrow) as far as it will go. Pull the lock barrel with induction coil out of the steering lock housing.

Note:  Inserting the steel wire (C) unlocks the lock barrel in the steering lock housing.

4. Carefully unlock and separate the plug connection on the lock barrel (at the induction coil for the immobilizer).

Installation 

1. Ignition lock with the pawl depressed must be in position 1 (ignition on).
2. Press on the pawl of the lock barrel (locking pawl). Insert the ignition key and turn the key as far as it will go to position 1 (ignition on). In this

position, insert the steel wire (C) that was used for removal.

3. Plug connector onto the ignition coil (B). Position the induction coil (B) and push the lock barrel all the way into the housing. Turn the ignition

key correspondingly, if necessary, until the lock barrel has been pushed in fully. Pull out the steel wire (C) in this position so that lock engages.

4. Connect battery ground cable. Perform function test.
5. If a new transponder (new lock barrel with new key) is used, the new key must be taught. 

Note:  The transponder is located in the key head. The new transponder is taught with the Porsche System Tester 2. A new transponder can be
adapted to the vehicle in the system "Alarm system", menu "Learning functions" / submenu "Check key". Access to WAS is necessary in order to
teach the transponder.

The transponder does not have to be taught if:
-

the previous key head A (handheld transmitter) is fitted on the new key C.

-

a new lock barrel with defined locking is installed (the entire previous key can thus be used).

-

the previous lock barrel with key is used.

Lock Barrel Replacement|Page 4800 > < Steering Column Lock|Diagrams|Page 4797