911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Seals and Gaskets: Service and Repair
Selector Shaft Seal
Removing and installing sealing ring for selector shaft
Tools
Removal
1. Remove multi-function switch console.
2. Disengage selector lever cable at transmission selector lever.
3. Drive out roll pin (1) until the selector lever can be pulled off from the shaft.
4. Pierce sealing ring with small screwdriver and pull out.
Installation
1. Thinly coat outer circumference and sealing lip of sealing ring with Vaseline.