911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-922003.png)
4.1 Pedal bearing axle
Greasing generally necessary. Lubricate sliding surfaces of the bearing bushings X and the pedal bearing axle with Optimal, Optitemp LG 2, Part
No. 000.043.203.37.
4.2 Clutch master cylinder push rod
Do not grease, as this could result in damage.
4.3 Area around boost spring
Depending upon the type of boost spring used, greasing is either necessary or not permitted. The following general rule applies: Do not grease
coated parts, as otherwise the coating is lost.
4.3.1 Carrera Mod. '98 / some Mod. '99
A. Boost springs installed as standard:
Push rod open on one side. Parts uncoated.
Grease pin for boost spring (arrow) with mating bearing on the boost spring push rod, the boost spring bearing (arrows) and the bearing pins on the
boost spring with Optimal, Optitemp LG 2, Part No. 000.043.203.37. First remove old grease with solvent naphtha.
The boost spring and interior of the boost spring housing are lubricated with a special grease. This grease is not available as a spare part. If
necessary, replace the complete boost spring (with housing).
B. Spare part replacement boost springs Part No. 996.423.081.11 (type used as of current Model '99 / <see Figure>). Distinguishing feature:
closed push rod, boost spring with purple marking and hexagon bolt for attachment to the clutch pedal.
