911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Fitting cylindrical-roller bearing with outer ring
1. Tap outer bearing ring (no. 12 in overview) in as far as the mounting face using special tool pressure pieces 9694/6 and pull-in tool and extractor p
254.
2. Lubricate cylindrical-roller bearing (no. 11 in overview) with transmission oil and insert it.
Fitting reversing-light switch
1. Screw reversing-light switch (no. 10 in overview) into the transmission cover.
Tightening torque: 18 Nm (13 ftlb.)
Fitting reverse idler gear
1. Insert shaft (no. 9 in overview) into the transmission cover. The threaded bore on the shaft must be aligned with the bore in the transmission cover.
2. Lubricate new needle-roller bearing (no. 8 in overview) with transmission oil and fit it on the shaft.
3. Fit reverse idler gear (no. 7 in overview) on the shaft.
4. Fit bearing segment (no. 6 in overview) on the shaft. The bore in the bearing segment must be aligned with the bore in the transmission cover.
5. Screw in hexagon-head bolt (no. 5 in overview).
Tightening torque: 25 Nm (19 ftlb.)
Subsequent work
1. Fit transmission cover.
2. Top up transmission oil.
3. Install transmission.