911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
13. Lay the red/brown lead -C- from the service wiring harness to the plug (black) of the alarm system control module, crimp the lead to the red/brown
lead, pin B8 - wiring diagram, external loads, terminal 30 - and insulate the lead. The leads must be watertight.
14. Insert the plug for the alarm control module and fit the control module to the floorpan.
15. Engage the tilt sensor on the tilt sensor bracket.
16. Insert the service lead plug into the tilt sensor.
17. Fit the parking assistant control module to the new cover -1- with the fastening screws and insert both plugs into the control module. Pay attention
to the new installation position.
18. Insert the tilt sensor -3- into the cover -1- and screw the cover tight to the floorpan using the fastening screws -arrow-.
19. Lay the lead under the cover, making sure that no electrical lead can be caught when the seat is operated.
20. Install the seat.
21. Make sure the system is functioning properly with the Porsche System Tester.
Tools