911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
Steering Mounted Controls Communication Module: Service and Repair
Removing And Installing Control Unit For Steering Wheel Electronics
Tools
Preliminary work
1. Remove driver's airbag unit.
2. Remove steering wheel.
3. Remove steering column trim.
4. Remove steering column switch.
Removing control unit for steering wheel electronics
INFORMATION:
-
The control unit for steering wheel electronics is bolted to the steering-column switch.
-
Before the ground strap of the battery is disconnected, the data in the control unit for steering wheel electronics must be read out using the Porsche
System Tester.
-
Ensure that the arrow -A- of the rotor is positioned between the markings -B- of the arrows -C- of the airbag contact unit and that the latch -D- is
engaged.
1. Remove contact unit.
1.1. Carefully lift up the three retaining tabs and remove airbag contact unit.
2. Unscrew fastening screws for steering wheel electronics control unit.