911 Carrera 4 Coupe (996) F6-3.6L (2002)
This check must only be carried out when the engine is not running.
Menu item
Function
-
MOST System check
Using this menu item, a MOST system
(ignition on.)
check can be carried out with the ignition on. The following checks are carried out automatically and their results
are displayed.
-
Gateway start-up condition is read out.
-
MOST installed components list (required and actual installed components list) is analysed.
-
Start the ring break diagnosis.
-
The results are displayed by the 9588 Porsche System Tester II
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select 'Cayenne' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM2' in the Control modules menu and confirm with the [>>] key.
-
Select 'MOST components check' in the PCM2 function selection and confirm with the [>>] key.
-
Select "MOST system check (ignition on)" in the Cayenne PCM2 MOST components check function selection
and confirm with the [>>] key.
Diagnosis, open circuit in distribution line (ignition on.)
This check must only be carried out when the engine is not running.
Menu item
Function
-
Diagnosis, ring break
The ring break diagnosis carries out the
diagnosis (ignition on.)
following checks:
-
Gateway start-up condition is read out.
-
MOST installed components list (required and actual installed components list) is analysed.
-
Start the ring break diagnosis.
-
The results are displayed by the 9588 Porsche System Tester II
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select 'Cayenne' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM2' in the Control modules menu and confirm with the [>>] key.
-
Select 'MOST components check' in the PCM2 function selection and confirm with the [>>] key.
-
Select "Ring break diagnosis (top)" in the Cayenne PCM2 MOST components check function selection and
confirm with the [>>] key.
-
Follow the Tester instructions.
Optical performance check
Menu item
Function
-
Optical performance check
The optical performance check allows the performance of the MOST to be checked optically. The following
checks are carried out automatically:
-
MOST installed components list (required and actual installed components list) is analysed.
-
External MOST components display.
-
Carrying out the performance check.
-
The result is displayed by the tester.
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select 'Cayenne' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM2' in the Control modules menu and confirm with the [>>] key.
-
Select 'MOST components check' in the PCM2 function selection and confirm with the [>>] key.
-
Select "Optical performance check" in the Cayenne PCM2 MOST components check function selection and
confirm with the [>>] key.
-
Follow the Tester instructions.
Data transmission check
Menu item
Function
-
Data transmission check
Using this menu item, the quality of the data transmission can be assessed.
This is a counter which leads to an increase in the value if faults occur within a certain time period. The check is
carried out continuously at predetermined intervals.
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select 'Cayenne' in the Vehicle type menu and confirm with the [>>] key.