911 Carrera 4 Coupe (996) F6-3.6L (2002)
General Module: Programming and Relearning
Calibration
Calibration
The control module can be calibrated under menu item Calibration.
Calibration is necessary in the following cases:
-
When replacing the servomotors for HBA
-
When replacing the entire headlights
-
When replacing the control module
-
When replacing angle sensors for HBA
-
When modifying the running gear
NOTE: Adjust the headlights after calibration.
Procedure:
1. Connect PST2 and switch on the ignition
2. Select vehicle type 911 (996) and start the automatic control module search.
3. Select control module HBA.
4. Select menu item Calibration and follow the instructions displayed by the PST2
NOTE: The servomotors will be activated in the three possible positions - max. position, centre position and min. position - during calibration.
Observe this process with the dipped beam switched on. Read out the fault memory after calibration.
Coding
Coding
A new control module can be coded in menu item Coding.
Procedure:
1. Connect PST2 and switch on the ignition
2. Select vehicle type 911 (996) and start the automatic control module search.
3. Select control module HBA.
4. Select menu item Coding.
5. Select vehicle type 911 (996) and start coding with the F8 key.
Country Coding
Country Coding
The following country versions can be coded under menu item "Country coding":
1. Row
2. Canada
3. Saudi-Arabia
4. Japan
Incorrect coding leads to malfunctions such as missing acoustic signals.
Speedometer A
Speedometer A
The menu item Speedometer A is used to test the speed-dependent volume control and the speed warning signal.
Procedure:
1. Connect PST2 and switch on the ignition
2. Select vehicle type 911 (996) and start the automatic control module search.
3. Select Instrument cluster control module
4. Select menu item Speedometer A
5. Simulate speed with Increase (F5) and Decrease (F6) buttons.
Coding