911 Carrera 4 Coupe (996) F6-3.6L (2002)
-
1: Camshaft adjustment valve (control chain side)
-
2: Valve lift adjustment valve
Tightening torque: 10 Mm (7.5 ftlb.)
13. Install ignition coils. Insert three ignition coils in the spark-plug recesses, position and then tighten two M6 x 25 hexagon socket head bolts.
Tightening torque: 10 Nm (7.5 ftlb.)
14. Install holder for the main muffler. Insert holder from the clutch side, position two M8 x 30 hexagon-head bolts at the top and two M8 x 25
hexagon-head bolts at the bottom and tighten, Connect the electrical plug of ignition coil cylinder 2 and the two electrical plugs of the
magnetic hydraulic valves, then fasten the cable in the sheetmetal brackets.
Tightening torque: 23 Nm (17 ftlb.)
15. Install the shield. Insert the shield, position and tighten the two M6 x 16 hexagon-head bolts.
Tightening torque: 10 Nm (7.5 ftlb.)
16. Turn the engine at the assembly support by approx, 90 degree until the engine is horizontal (intake system at the top).
Tightening Torques For Installing Camshaft