911 Carrera 4 Coupe (996) F6-3.6L (2002)
NOTE:
-
Always replace O-ring of the hydraulic valve and the retainer plate.
-
Observe installation position of the hydraulic valve.
1. Replace the O-ring of the hydraulic valve and coat the new O-ring with engine oil. Insert hydraulic valve into the cylinder head, paying attention to
the installation position (groove on valve -arrow- faces the dowel pin in the cylinder head).
Dowel pin in cylinder head
2. Coat seal of the retainer plate with engine oil and slide it over the hydraulic valve.
3. Fit both M6 pan-head screws (hexagon socket a/f 5) complete with holder -A- on the valve and tighten the screws.
Tightening torque 10 Nm (7.5 ftlb.)
4. Push the cable plug onto the hydraulic valve again. Make sure that the plug audibly engages.
5. Fit the side shield on the respective side of the engine. Put on and tighten the two M6 hexagon-head bolts for this purpose.