911 Carrera 4 Coupe (996) F6-3.6L (2002)
It is possible to read out the unlock counter under the 'Actual values' menu item.
Menu item
Function
-
Unlock counter
Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting.
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select '911 (996)' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM' in the Control modules menu and confirm with the [>>] key.
-
Select 'PCM2 GW' in the PCM2 function selection and confirm with the [>>] key.
-
Select 'Actual values' in the PCM2 GW function selection and confirm with the [>>] key.
-
Select "Unlock counter" in the PCM2 GW actual values function selection and confirm with the [>>] key.
-
Read out values from the display field.
Audio Tests
Audio Tests
The following functions can be run using this menu item:
-
Manual single selection.
-
Automatic test.
Menu item
Function
-
Manual single selection.
This menu item allows you to carry out a manual audio test on vehicles with an internal amplifier.
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select '911 (996)' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM' in the Control modules menu and confirm with the [>>] key.
-
Select 'PCM2 GW' in the 911 (996) PCM2 function selection and confirm with the [>>] key.
-
Select 'Audio tests' in the PCM2 GW function selection and confirm with the [>>] key.
-
Select "Manual single selection" in the PCM2 GW audio tests function selection and confirm with the [>>]
key.
-
Select the required loudspeaker system and confirm with the [>>] key.
The following selection is available:
-
Front left, test frequency 1 kHz
-
Front right, test frequency 1 kHz
-
rear left, test frequency 1 kHz
-
rear right, test frequency 1 kHz
-
[F5] Boost volume
-
[F6] Lower volume
-
[F8] Start test
-
Automatic test.
This menu item allows you to carry out a automatic audio test on vehicles with an internal amplifier.
-
Connect and start the 9588 Porsche System Tester II and switch on the ignition.
-
Select '911 (996)' in the Vehicle type menu and confirm with the [>>] key.
-
Select 'PCM' in the Control modules menu and confirm with the [>>] key.
-
Select 'PCM2 GW' in the 911 (996) PCM2 function selection and confirm with the [>>] key.
-
Select 'Audio tests' in the PCM2 GW function selection and confirm with the [>>] key.
-
Select the menu item 'Automatic test' and confirm with the [>>] key.
The test sequence is automatic.
Identification
Identification
The diagnosis software number and the part numbers for the PCM2 can be read out under this menu item.
1. Connect and start the 9588 Porsche System Tester II and switch on the ignition.
2. Select '911 (996)' in the Vehicle type menu and confirm with the [>>] key.
3. Select 'PCM' in the Control modules menu and confirm with the [>>] key.
4. Select 'PCM2 GW' in the PCM2 function selection and confirm with the [>>] key.
5. Select 'Identification' in the PCM2 GW function selection and confirm with the[>>] key.
6. 'Diagnosis software number; PCM2 part number' appears on the display.
Input Signals