911 Carrera 4 Coupe (996) F6-36L (2002) - Engine Control Module - Diagrams - Page 445
"Input new immobilizer code"
Input immobilizer code and press the double arrow key [>>].
16. The following message appears on the screen:
"Please confirm input"
Confirm input with the [F7] key.
17. The following message appears on the screen:
"Select data record"
Select data record according to the allocation table and press the double arrow key [>>].
The control module will now be programmed. Programming will take approx. 5 minutes.
WARNING: Never interrupt the programming process
18. The following message will appear after the programming time has elapsed:
"Programming was completed successfully"
Press the double arrow key [>>], switch the ignition off and then on again.
This completes programming of the DME control module.
Allocation table
NOTE:
-
The DME control module can also be reprogrammed using the Porsche System Tester 2. In this case, the old data record will be overwritten by a
new record (e.g. RoW instead of Germany)
-
Program map/data must be selected in Step 7 if reprogramming is necessary.
WARNING:
Risk of damage if allocation is incorrect.
-
Ensure correct allocation of the data record in the control module to the installed catalytic converter (refer to the allocation table)