911 Carrera 4 Coupe (996) F6-3.6L (2002)
Prepare vehicle for checking and/or adjustment of wheel alignment values. Place front wheels on rotary table and rear wheels on rotary / sliding
plates. Compress vehicle at front and rear by approximately 25 mm 2-3 times and allow it to spring back freely.
Adjusting toe
After loosening the lock nut, turn eccentric A appropriately.
Adjusting camber
After loosening the lock nut, turn eccentric B appropriately.
Note: Use special tool 9626 in combination with a torque wrench to loosen and tighten the lock nuts of the toe and camber eccentrics. The
prescribed lock nut tightening torque of 100 Nm (74 ft. lbs.) corresponds to a setting on the torque wrench of approximately 85 Nm (63 ft. lbs.).
Front axle
Adjusting camber*
The camber is adjusted by moving the spring strut transversely. For this purpose, loosen the three fastening nuts on the spring-strut mount and, to
move the spring strut, remove the covering cap on the piston rod.
Adjusting caster*
The caster is not adjustable on standard vehicles. In the event of repairs, a caster adjustment facility can be installed if necessary (as with the
Boxster).
Refer to Installing Caster Eccentric under Control Arm for a description and for requirements.
*
The steering angle sensor must be calibrated if the previous wheel alignment values for vehicles with PSM (Porsche Stability Management)
were changed!
Adjusting toe*
Preliminary work: Check whether the steering wheel is displaced with respect to the steering gear. To do this, center the steering gear as described
below.