911 Carrera 4 Coupe (996) F6-3.6L (2002)
2. Insert control module into the holder and engage holder -4-.
3. Plug in the electrical plug connection.
4. Position the support and engage in lower side member.
5. Push in the locating peg -1- of the support and check that it is sifting correctly.
6. Tighten the fastening nuts -3- and the fastening screws -2-.
Tightening torque -2- 7.2 Nm (5.5 ft. lbs.).
7. Lay the floor covering over the support and engage.
^
Using the Porsche System Tester, read out any faults present in the POSP menu and erase.
^
Insert sill.
^
Mount the side lining at rear.
^
Installing front seat.
Coding Tiptronic control module
Note!