911 Carrera 4 Coupe (996) F6-3.6L (2002)
Installing selector force mechanism
1. Insert compression spring (no. 9 in overview) into transmission housing.
2. Insert lid (no. 8 in overview) and circlip (no. 7 in overview) into the bore on the housing.
3. Use special tool press-out mandrel p 375 to press the lid and circlip down until the circlip engages in its groove.
Installing bleeder
Information
^
Check installation depth of the bleeder, see illustration.
1. Tap bleeder (no. 5 in overview) into the transmission housing with a rubber hammer.
2. Fit cap (no. 6 in overview) on bleeder.
Installing sliding latch
1. Insert sliding latch (no. 4 in overview) into the transmission housing at the correct position and screw in Torx screws (no. 3 in overview).
Tightening torque: 20 Nm (15 ftlb.)
Subsequent work
1. Assemble transmission.
2. Fill with transmission oil.
3. Install transmission.