911 Carrera 4S (996) F6-3.6L (2004)
4. Remove retainer plate with integral seal -3- from the valve.
5. Carefully pull the hydraulic valve out of the cylinder head using special tool (relay puller) 9235.
Installing hydraulic valve for camshaft adjustment
Information
-
Always replace O-ring of the hydraulic valve and the retainer plate!
-
Observe installation position of the hydraulic valve!
1. Replace the O-ring of the hydraulic valve and coat the new O-ring with engine oil. Insert hydraulic valve into the cylinder head, paying attention to
the installation position (groove on valve -arrow- faces the dowel pin in the cylinder head).