911 Carrera 4S Coupe AWD F6-3600cc 3.6L SOHC (1997)
Front Wheel Bearing (Part 2 Of 2)
NOTE:
-
During service procedures, refer to the illustration above and the information below.
-
Observe correct combination when replacing wheel hub and/or the spring washer - in the case of '94 (R) model vehicles. Observe the "Technical
Information" - Group 4, No. 2/94 - for this purpose.
Preliminary work
-
Undo the screw connection between wheel hub and wheel bearing or the drive shaft fastening (in the case of all-wheel drive vehicles) before lifting
the vehicle or removing the wheel bearing housing (wheel carrier).
-
Remove wheel carrier, brake disc and speed sensor.
Removal
-
Press out rear-wheel hub with pressure piece P 297 A (tool A).
Use the separator (tool B) for support.
If there is not enough space for the wheel hub between the press, appropriate shims will additionally be necessary.
-
Remove brake disc cover and lid for the wheel bearing (four screws).